Video Recap: July 9thPosted By Michael Goris
Alarm Grid has a short but sweet video recap for you! Last week's recap was skipped to spread the cheer about our headquarters reopening, but we're here now! Unfortunately, we only have three (3) videos to share. Also, our usual team wasn't quite ready yet, so I had to make more appearances.
This week's videos are centered around the 2GIG GC3e Security System. This is a wireless all-in-one panel with support for encrypted 2GIG eSeries Sensors, as well as non-encrypted 345 MHz sensors. The system has a beautiful 7-inch touchscreen, built-in WIFI, partitioning support, and an integrated Z-Wave Plus controller. We hope these videos help you feel more comfortable in setting up your own 2GIG GC3e System for your home or business!
Pairing a Z-Wave Device to the 2GIG GC3e
I show you how to pair a Z-Wave device with the 2GIG GC3e. The GC3e has a built-in Z-Wave Plus controller, which allows you to pair Z-Wave Plus and classic Z-Wave devices with the system. Common Z-Wave devices include lights, door locks, thermostats, and more. Programmed Z-Wave devices can be controlled from the panel and remotely from Alarm.com if the system is monitored. Most Z-Wave devices are excluded, or cleared, from the network before being added.
Programming a Key Fob Into a 2GIG GC3e
I show you how to add a key fob to a 2GIG GC3e. A key fob is a small handheld device that you can use to control your security system from a distance. Most key fobs will allow you to conveniently arm and disarm your system and operate programmed relay-triggered devices. Many key fobs also have the ability to set off panic alarms in distress situations. The 2GIG GC3e supports various 345 MHz wireless key fobs.
Adding or Changing User Codes on a 2GIG GC3e
I show you how to add, change, and delete user codes on a 2GIG GC3e. A user code is a sequence of numbers that you enter into a system to verify that you are an authorized user. The 2GIG GC3e supports up to 100 user codes. It is advised that each regular user has their own code. Each new code on the GC3e must be enabled for the use with system after it has been added.